Author Topic: ECU not Visible - 2000 R1150GS  (Read 66751 times)

Jughead

  • Beta testers
  • Hero Member
  • *
  • Posts: 769
  • Karma: +51/-3
    • Dual Sport Motorcycle Clinic
Re: ECU not Visible - 2000 R1150GS
« Reply #45 on: August 18, 2015, 08:14:51 AM »
I'm about ready to get out the 357Mag though  >:( >:( >:( >:(

Stop being so elusive!  ;D

Out with it, NOW!  What have you not got?  Spark or fuel?

Onions

  • Newbie
  • *
  • Posts: 39
  • Karma: +0/-0
Re: ECU not Visible - 2000 R1150GS
« Reply #46 on: August 18, 2015, 12:30:28 PM »
Don't know yet.

Got the 4 new relays in and haven't been able to get any spades small enough to make the link cable for the side stand switch so will have to take the smallest ones I got this arvo and squeeze them down to fit. Once sorted will do the spark and fuel test and come back to you. :P

Onions

  • Newbie
  • *
  • Posts: 39
  • Karma: +0/-0
Re: ECU not Visible - 2000 R1150GS
« Reply #47 on: August 19, 2015, 01:33:12 AM »
Jughead.

Ur probably still in bed lucky sod. It's 930 here.

Ran side stand loop, 4 new relays ignition on - no spark.

Took side stand loop out - ignition on again - no spark.

Didn't check fuel as I would say it is geeting through - I can smell it.

I goota attend to some other matters so by the time I get back u should be up and about.  FARK.

Onions

  • Newbie
  • *
  • Posts: 39
  • Karma: +0/-0
Re: ECU not Visible - 2000 R1150GS
« Reply #48 on: August 19, 2015, 01:43:43 AM »
Also whatever it is appears to drain battery very quickly - after 3 to 4 starts labours hard.

Battery is good been checked out by Battery World (Specialists).

Jughead

  • Beta testers
  • Hero Member
  • *
  • Posts: 769
  • Karma: +51/-3
    • Dual Sport Motorcycle Clinic
Re: ECU not Visible - 2000 R1150GS
« Reply #49 on: August 19, 2015, 06:43:06 AM »
Jughead.

Ur probably still in bed lucky sod. It's 930 here.

Ran side stand loop, 4 new relays ignition on - no spark.

Took side stand loop out - ignition on again - no spark.

Didn't check fuel as I would say it is geeting through - I can smell it.

I goota attend to some other matters so by the time I get back u should be up and about.  FARK.

OK.

Remove the front engine cover and check to see whether the alternator pulley (the one you removed to replace the HALL sensor) is still in place.  Unfortunately that bolt is not a left hand thread and will tend to unscrew itself if not tightened properly, leaving you without the pulse for the coils.

Did you lock the motor when you tightened the bolt?

Onions

  • Newbie
  • *
  • Posts: 39
  • Karma: +0/-0
Re: ECU not Visible - 2000 R1150GS
« Reply #50 on: August 19, 2015, 06:47:39 AM »
No didn't lock the motor. Didn't think I would have to.

Jughead

  • Beta testers
  • Hero Member
  • *
  • Posts: 769
  • Karma: +51/-3
    • Dual Sport Motorcycle Clinic
Re: ECU not Visible - 2000 R1150GS
« Reply #51 on: August 19, 2015, 06:49:54 AM »
Ah!

My bet is that it has unscrewed itself, leaving you screwed!  ;D

Onions

  • Newbie
  • *
  • Posts: 39
  • Karma: +0/-0
Re: ECU not Visible - 2000 R1150GS
« Reply #52 on: August 19, 2015, 06:56:14 AM »
Be as close as I have gotten in a long time OK I'll go and pull cover and get back to you.

Is their a locking pin port in the front of the motor - I know there's one at the flywheel.

Onions

  • Newbie
  • *
  • Posts: 39
  • Karma: +0/-0
Re: ECU not Visible - 2000 R1150GS
« Reply #53 on: August 19, 2015, 07:08:17 AM »
U were right I'm screwed it came undone - I'll locktite the sucker this time.

Jughead

  • Beta testers
  • Hero Member
  • *
  • Posts: 769
  • Karma: +51/-3
    • Dual Sport Motorcycle Clinic
Re: ECU not Visible - 2000 R1150GS
« Reply #54 on: August 19, 2015, 07:11:07 AM »
Be as close as I have gotten in a long time OK I'll go and pull cover and get back to you.

Is their a locking pin port in the front of the motor - I know there's one at the flywheel.

No, no locking port on the front.  Only on the flywheel.

Glad you came right.  Now go ride the bike!   ;D
« Last Edit: August 19, 2015, 08:02:40 AM by Jughead »

Onions

  • Newbie
  • *
  • Posts: 39
  • Karma: +0/-0
Re: ECU not Visible - 2000 R1150GS
« Reply #55 on: August 19, 2015, 07:39:54 AM »
It lives. I'll wait half for the locktite to go off.

Jug if u or Wayne C are ever over here in Brisbane Qld Australia let me know I'll buy you a beer and you can borrow one of my bikes to ride.

Thanks muchly for your help.

Jughead

  • Beta testers
  • Hero Member
  • *
  • Posts: 769
  • Karma: +51/-3
    • Dual Sport Motorcycle Clinic
Re: ECU not Visible - 2000 R1150GS
« Reply #56 on: August 19, 2015, 08:06:14 AM »
[emoji106]

WayneC

  • Beta testers
  • Hero Member
  • *
  • Posts: 1520
  • Karma: +34/-1
Re: ECU not Visible - 2000 R1150GS
« Reply #57 on: August 19, 2015, 10:17:58 AM »
Ah a bloody Queenslander causing problems, should have known  ;D, Pleased you have it sorted, I may have further info on your model lying round if you want it, not for the forum here though so get hold of my via my web site f650gs.crossroadz.com.au, contact form is in the about section

Onions

  • Newbie
  • *
  • Posts: 39
  • Karma: +0/-0
Re: ECU not Visible - 2000 R1150GS
« Reply #58 on: August 19, 2015, 10:59:06 AM »
The Maroons rule mate.

WayneC

  • Beta testers
  • Hero Member
  • *
  • Posts: 1520
  • Karma: +34/-1
Re: ECU not Visible - 2000 R1150GS
« Reply #59 on: August 19, 2015, 01:45:08 PM »
Jughead so you understand the Oz humour

Maroons are footballers with a touch of the sun who dress in dark pink and play an irrelevant Australian form of football better known as thugby, the opposing team from the only southern state silly enough to like thugby dress in blue which is probably a good idea as they have been perennial losers for the last decade or so. There are even annual bets between the political leaders of these States as to whose team is the biggest bunch of thugs.  ;D ;D