General Category > Central Vehicle Electronics/ZFE/GM issues

10219CAN-bus error

<< < (5/6) > >>

schuppi:
good evening 8) :)

i don't understand "can high on 1  and can low on 2"...how can i check them??  In the connector of Kombi
uups, thought it was clear. The same procedure, from ZFE to Kombi.

another uuupps:
a friend of mine made for me the wire from tom tom to bike connector and
i am pretty sere i see little flash.

So disconnect this retrofit, check this cables and those who are close to them to ZFE for short circuit.
Hope this helps to find it out

ciri:
hi
i already disconnected the cable from the plug (near the radiator, there is a plug made for navigators...)  when the first time battery went low...



sorry but i don't know what kombi is...where is the plu??

many thanks

schuppi:
CAN-Kombi H/LCluster type: CAN-Kombi H/L
Part No.: 7725817
Hardware Index: 7
Coding Index: 7
Manufacturer: Siemens VDO Automotive

That's the display panel / dash board / Anzeigeeinheit / Kombiinstrument /  8) ;)

ciri:
here my 2 connectors...

http://imgur.com/3wU8BLn,4WSe19H
http://imgur.com/3wU8BLn,4WSe19H#1
Hi ciri,
if the VIN is right pin 30 and 15 at ABS are right.
Please check wire colours in the ABS connector.
15 = white/brown
30 = white/black

schuppi:
Hi ciri,
so just I'm a little bit confused :-\, can't find such a connector as you figured in picture 2? It's not the same as showed
in the wiring diagram. So I don't know how to give more help? In my document the ABS connector has 47 pins?

Picture 1 looks like ZFE.
And Picture 2 seems to be from BMS-K Motor ECU?

I will try to find it :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page