Beta version 1506.1 released

[kobus]

After I replaced my rear strut last winter, I had to go to the dealer to reprogram the ZFE. (My new strut has a HALL sensor, the original one did not.)

I have to agree with schuppi.
Your previous ESA did not have a HALL sensor and therefore does not show in ZFE config (only HALL sensor type is in ZFE config). When they replaced the strut they did not update ZFE coding for the new strut.

But glad to hear that the calibration works.

[Dann]

I have to agree with schuppi.
Your previous ESA did not have a HALL sensor and therefore does not show in ZFE config (only HALL sensor type is in ZFE config). When they replaced the strut they did not update ZFE coding for the new strut.

That makes sense, but they did upgrade something in the ZFE because the GS-911 cannot ID the Actual I-Level.

Since I can do the calibration, it's not that important if the ESA shows up or not in the Autoscan report.

[schuppi]

but they did upgrade something in the ZFE?

Hi Dann,
no they didn't. Because the Auto-Scan take information out of the ZFE to look for controllers. If there is no ESA, also no matter for
read this module.
Otherwise, you adressed ESA directly GS911 will find it.