Author Topic: Cant configure channels  (Read 2788 times)

Stringman

  • Newbie
  • *
  • Posts: 7
  • Karma: +1/-0
Cant configure channels
« on: May 28, 2025, 11:17:02 PM »
Hi

I have a ezCAN gen 2 fitted to a BMW F800GT

I Cannot configure the channels.

I have connected 2 (yellow) spotlights to the red channel, 2 (white) spotlights to the blue channel  and a led brake light to the yellow channel. The white channel is unused.

I have tested the channels via the diagnostics page and used the slider to check the outputs are ok, and all is good.

I can change the configuration of the channels (red to aux1, blue  aux2, yellow brake)  and I have tried pressing apply after each change and also and the end of the 3 changes. The apply box does not seem to change when clicked on though.

But the moment I go into the menu  to change the  configuration of the channel the 4 channels change back to the default settings.

I have made these settings with the ignition on but not the engine running. Would that affect it.

I have looked at the youtube videos and cant see that I am doing anything wrong

Stringman

  • Newbie
  • *
  • Posts: 7
  • Karma: +1/-0
Re: Cant configure channels
« Reply #1 on: May 29, 2025, 03:24:02 PM »
Update

following the advice on: post#7
https://www.r1200gs.info/threads/hex-ezcan-problems.56867/

I reset the device.
Still no joy I tried changing the screen resolution on my laptop from native 3840x 2160 to 1920x1080. Then I could apply the settings for the red channel. Tried the blue channel - no joy. bounced back the resolute to native and I could apply the settings!!!
Every time i wanted to apply a change I had to change the resolution.
Stupidly frustrating but at least I am all configured and up and running!