Author Topic: anyone familiar with this code? 0x3A1122 Thanks!  (Read 8029 times)

lil.s1k

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
anyone familiar with this code? 0x3A1122 Thanks!
« on: August 03, 2024, 01:40:38 AM »
bike keeps shutting off for this code 0x3A1122 (Fuse activated for Ignition component protection, overload)

GS Jim

  • Full Member
  • ***
  • Posts: 243
  • Karma: +10/-0
Re: anyone familiar with this code? 0x3A1122 Thanks!
« Reply #1 on: August 03, 2024, 11:35:37 PM »
This is what I heard :

Disconnect all components specified below and delete the fault memory.
With all components disconnected, if the fault memory entry is
present: Check the wiring harness for insulation damage.
not present: Reconnect all components step by step until the fault is entered again.
Components of the component group 2:
Fuel injectors
Ignition coils
If installed:
Unfiltered-air flap controller

After rectifying the fault, reset the mixture preparation adaptation values.

hoss_cartwright

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: anyone familiar with this code? 0x3A1122 Thanks!
« Reply #2 on: September 08, 2024, 11:18:42 PM »
bike keeps shutting off for this code 0x3A1122 (Fuse activated for Ignition component protection, overload)

Did a solution present itself? did you take Jim's advice?

Thealmightyhabibi

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: anyone familiar with this code? 0x3A1122 Thanks!
« Reply #3 on: November 19, 2024, 11:02:00 AM »
Had this issue pop up on me this evening… following to see if issue was resolved

hoss_cartwright

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: anyone familiar with this code? 0x3A1122 Thanks!
« Reply #4 on: November 19, 2024, 11:55:41 AM »
Initially, I cleared the code by disconnecting the battery after a coil failed. However, the issue resurfaced a few weeks later, likely due to a faulty O2 sensor. To resolve it, I disconnected all the coils and fuel injectors. Once I reconnected everything, the code cleared successfully, and the engine started without issue.

Thealmightyhabibi

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: anyone familiar with this code? 0x3A1122 Thanks!
« Reply #5 on: November 30, 2024, 07:15:19 AM »
Problem solved… checked each coil pack individually until code popped up. Swapped coil pack, replugged all wires back cleared all codes and turned the bike on with no faults.