Measure the pressure sensor...

[knappen]

Okay... and cross my fingers right? 

Do i need any silicone to seal, or is it okay to reuse the rubber seal?

[Jughead]

Okay... and cross my fingers right? 

Do i need any silicone to seal, or is it okay to reuse the rubber seal?

To seal what?

[knappen]

aah... sorry... i do mean the sensor on the outside ( the one with long cable ) there is a black rubber seal, can i reuse the rubber seal for it to be totally sealed?

[Jughead]

aah... sorry... i do mean the sensor on the outside ( the one with long cable ) there is a black rubber seal, can i reuse the rubber seal for it to be totally sealed?

Yes you can.  No silicon required.

[knappen]

Did solder it my self.. it ain't pretty but i work and the ABS pump gives no warning lights.
I do have some faultcodes in memory but it says NO under the fault.

But big THANKS for the HELP ! 

[Jughead]

Did solder it my self.. it ain't pretty but i work and the ABS pump gives no warning lights.
I do have some faultcodes in memory but it says NO under the fault.

But big THANKS for the HELP ! 

Awesome!  Congrats!  [emoji106]

[knappen]

Thanks...  But i could not have done it without your help 

The bike is together now and the brakes works fine 

[Jughead]

Thanks...  But i could not have done it without your help 

The bike is together now and the brakes works fine 

[emoji106]  Glad to be of assistance.

[knappen]

so i found another ABS pump and took out the sensors... did some measurement, what do you think about these values?

 

[Jughead]

Front wheel sensor looks a little high, but you now know how to resolve that issue, 

[knappen]

Well i guess that you are right... just do it right the first time 😀

[knappen]

i did solder it and now it does not work on the rear... there is no power to it... 
Do you have a solution for this?

It work fine when i tested it first, the values was fine but after the soldering something happened...
It seems like the electronic board(computer/circuit board) does not work all the time, it gives power sometimes and sometimes not

[knappen]

so.. still fighting with my abs

Having fault codes but it comes and goes it says:
24971
Pressure in front wheel circuit too high
The fault is not present now.


but the values are perfect. Could this comes from air in the system?

[Jughead]

It is possible that you have an intermittent problem with the sensor.  It senses pressure too high, logs the error code, then returns to normal by the time you take the readings.

[knappen]

so what shall i do? change the sensor.. change the ABS pump? or try to bleed the system again?