Author Topic: Resetting the adaptations values when engine is cold or hot?  (Read 722 times)

GvG

  • Newbie
  • *
  • Posts: 9
  • Karma: +0/-0
Resetting the adaptations values when engine is cold or hot?
« on: September 19, 2018, 08:05:12 PM »
What's the right thing to do; resetting the adaptations values when the engine is cold or hot (at operating temperature)?

Particularly these:
- throttle twist-grip sensor,
-throttle valve sensor,
-transmission position sensor.

Thanks in advance!

stardust_59

  • Newbie
  • *
  • Posts: 21
  • Karma: +1/-0
Re: Resetting the adaptations values when engine is cold or hot?
« Reply #1 on: September 25, 2018, 06:50:44 PM »
Hi GvG,

as I went through the drill myself:

Adaptation reset is usually done with engine cold.
After adaptation reset is done  run the engine at idle until warm (80 or 90 deg Celsius  - or fan turns on if watercooled).
Since I do not know which bike you refer to - this is the procedure for the F650 (single, FI model)

If you reset adaptation values - upon success - the GS 911 software will guide you trough the process.


HTH

Jan

Vrabel

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Re: Resetting the adaptations values when engine is cold or hot?
« Reply #2 on: October 23, 2018, 11:48:48 AM »
Just out of curiosity, what can happen if the adaptation reset was done with the engine hot?