Author Topic: How do you get the VIN and Mileage to display in the AutoScan Report? (Read 10090 times)

schuppi · « **Reply #1 on:** August 04, 2015, 09:39:41 AM »

Automatically. But only by CAN-BUS based motorbikes, where you can read the dashboard (Kombi)

mlpopovich · « **Reply #2 on:** August 04, 2015, 01:56:19 PM »

It's an '05 LT w/CANBUS, but in the MC Info section of the AutoScan Report the VIN is blank and the Mileage says "Not Available".

schuppi · « **Reply #3 on:** August 04, 2015, 03:03:36 PM »

Hello
Just the time to ask for auto-scan.

If there is a Motronic MA 2.4 mounted, I'm sure that there will be no mileage and VIN display.
The other point is BMS-K. This ECU in combination with "Kombi"

shows mileage and VIN

mlpopovich · « **Reply #4 on:** August 05, 2015, 03:32:19 PM »

Thanks for the information! As far as I can tell, my '05 LT has a Motronic MA 2.4 controller. I'm not sure what all the implications are for the use of the GS 911, but I'm sure that I'll find out. Any advice in this matter is greatly appreciated.

News:

Author Topic: How do you get the VIN and Mileage to display in the AutoScan Report? (Read 10090 times)

mlpopovich

How do you get the VIN and Mileage to display in the AutoScan Report?

schuppi

Re: How do you get the VIN and Mileage to display in the AutoScan Report?

mlpopovich

Re: How do you get the VIN and Mileage to display in the AutoScan Report?

schuppi

Re: How do you get the VIN and Mileage to display in the AutoScan Report?

mlpopovich

Re: How do you get the VIN and Mileage to display in the AutoScan Report?