anyone familiar with this code? 0x3A1122 Thanks!

[lil.s1k]

bike keeps shutting off for this code 0x3A1122 (Fuse activated for Ignition component protection, overload)

[GS Jim]

This is what I heard :

Disconnect all components specified below and delete the fault memory.
With all components disconnected, if the fault memory entry is
present: Check the wiring harness for insulation damage.
not present: Reconnect all components step by step until the fault is entered again.
Components of the component group 2:
Fuel injectors
Ignition coils
If installed:
Unfiltered-air flap controller

After rectifying the fault, reset the mixture preparation adaptation values.

[hoss_cartwright]

bike keeps shutting off for this code 0x3A1122 (Fuse activated for Ignition component protection, overload)

Did a solution present itself? did you take Jim's advice?

[Thealmightyhabibi]

Had this issue pop up on me this evening… following to see if issue was resolved

[hoss_cartwright]

Initially, I cleared the code by disconnecting the battery after a coil failed. However, the issue resurfaced a few weeks later, likely due to a faulty O2 sensor. To resolve it, I disconnected all the coils and fuel injectors. Once I reconnected everything, the code cleared successfully, and the engine started without issue.