- I made service on my R1150RT 2002, before service no error.
After change brake fluid i was folowing a Youtupe video, first pumpe out on the 6 places on the ABS block.
After oppen the container in on the ABS block and flushing to the wheel's
After i use my GS 911 to check everything seams fine.
My first ride on the Bike i got ABS error after 15Km. Ride
Home to put GS 911 on to see the error:
Fault Code Value 17438(0x441E)
Fault Code Description Pressure in rear wheel circuit too high
When i read values then i got about 400 bar on the circuit
Today i start over and did a 2 times alle the steps to puss out air if there was somthing,
When i turnd on the bike to move it to the Lift i didn't have Error on the ABS.
After the 2 times taking fluid out i again got Error
now just whit a much lower value
Tail light OK
Brake light OK
Motor Front OFF
Motor Rear OFF
Brake light switch front (if fitted) Not Actuated
Brake light switch rear (if fitted) Not Actuated
Brake Fluid Level OK
Brake Active Front ON
Brake Active Rear OFF
Front wheel speed 0.0 km/h
Rear wheel speed 0.0 km/h
Battery voltage 9.75 V
Pressure Wheel Circuit Front 21.0 Bar
Pressure Wheel Circuit Rear 56.4 Bar
Pressure Control Circuit Front 17.0 Bar
Pressure Control Circuit Rear 18.9 Bar
Sorry my english
