General Category > ABS related issues
Measure the pressure sensor...
Jughead:
Yoh! Difficult question. Unfortunately with these pumps it is very much a matter of trial and error. I would replace the sensor to start with.
knappen:
i replaced the whole ABS unit/pump i hade a used one...
But now i wonder how does the Bleeding work with the GS-911? I run the software... right? But do i have to open any nipple to let the air out... if so... witch one? The ones on the wheels or on the ABS unit( witch one of the 6 ? )
mike d:
The GS-911 Bleed test is just that. A test to see if you have any trapped air in the system AFTER you performed the physical bleed operation.
The following is just one of a number of explanations on how to perform the actual bleed sequence.
https://www.ukgser.com/technical/nick/Brake%20bleeding%20(All%20BMW%20EVO%20systems,%20%2704-%2707).pdf
Mike
Jughead:
--- Quote from: mike d on May 23, 2020, 11:15:49 AM ---The GS-911 Bleed test is just that. A test to see if you have any trapped air in the system AFTER you performed the physical bleed operation.
The following is just one of a number of explanations on how to perform the actual bleed sequence.
https://www.ukgser.com/technical/nick/Brake%20bleeding%20(All%20BMW%20EVO%20systems,%20%2704-%2707).pdf
Mike
--- End quote ---
Agreed. This is one of the best write-ups for bleeding these systems.
knappen:
okay thanks guys for the help :)
Navigation
[0] Message Index
[*] Previous page
Go to full version