General Category > ABS related issues
Measure the pressure sensor...
knappen:
Well i guess that you are right... just do it right the first time 😀
knappen:
i did solder it and now it does not work on the rear... there is no power to it... :(
Do you have a solution for this?
It work fine when i tested it first, the values was fine but after the soldering something happened...
It seems like the electronic board(computer/circuit board) does not work all the time, it gives power sometimes and sometimes not
knappen:
so.. still fighting with my abs
Having fault codes but it comes and goes it says:
24971
Pressure in front wheel circuit too high
The fault is not present now.
but the values are perfect. Could this comes from air in the system?
Jughead:
It is possible that you have an intermittent problem with the sensor. It senses pressure too high, logs the error code, then returns to normal by the time you take the readings.
knappen:
so what shall i do? change the sensor.. change the ABS pump? or try to bleed the system again? :-\ :'(
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version