General Category > ABS related issues
Measure the pressure sensor...
Jughead:
Just another thought. When you change the pump over, swap the control unit. In other words, use the same control unit that belongs in your bike for both pumps.
knappen:
Hi Jughead and thanks for the reply!
I have use the control unit that belongs to my bike for both of the ABS pumps... the second hand control unit (the one with the big connection) did not work or respond at all.
I tried another combination:
The short one (with black socket) from my bike and the long one ( with white socket) with the second hand unit.
I have hard time to figure out witch ones are broken lol
Jughead:
--- Quote from: knappen on May 05, 2020, 01:28:20 PM ---Hi Jughead and thanks for the reply!
I have use the control unit that belongs to my bike for both of the ABS pumps... the second hand control unit (the one with the big connection) did not work or respond at all.
I tried another combination:
The short one (with black socket) from my bike and the long one ( with white socket) with the second hand unit.
I have hard time to figure out witch ones are broken lol
--- End quote ---
Green circles are 100%
Red arrow is the faulty one.
knappen:
So the one with long cables are broken and 1 black one is okay... the other black one might be okay? there is a difference one value 10.07 and the other 22.65 so it might work or maybe not... right?
Jughead:
--- Quote from: knappen on May 05, 2020, 02:03:41 PM ---So the one with long cables are broken and 1 black one is okay... the other black one might be okay? there is a difference one value 10.07 and the other 22.65 so it might work or maybe not... right?
--- End quote ---
Yes!
How well can you solder?
What you can try is to cut the long cable off about 50mm from the sensor end. Then cut the short cable off the spare sensor at the same point and solder the long cable onto the spare sensor. Just use heatshrink to insulate the solder joints.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version