General Category > Introduce yourself...

New here

<< < (2/3) > >>

mibridger:
Hi again,
How do I invoke D2D mode?
I looked up Device 2 Device mode, but I don’t know how to activate it.

Kind regards,

Mark.

mibridger:
Hi Jughead,

OK, now I get it, I am reading the user guide and it’s clear that the service functions only on the PC version.

I will download the PC version and try again to invoke the service function.

Kind regards,

Mark.

Jughead:

--- Quote from: mibridger on June 19, 2019, 09:03:52 PM ---Hi Jughead,

OK, now I get it, I am reading the user guide and it’s clear that the service functions only on the PC version.

I will download the PC version and try again to invoke the service function.

Kind regards,

Mark.

--- End quote ---

According to the Function Chart you should be able to reset the service reminders on the XR directly when connected via normal WiFi connection. 

Note, however, that the service reset function uses cloud functionality, so you would need access to the cloud from the same device that you are using to connect to the GS911. 

Unfortunately most devices like iPads, tablets and smartphones only permit 1 external connection, meaning that if you use that 1 connection to establish comms to the GS911 in D2D mode, you then have no comms to the cloud.  This is not a GS911 restriction.  This is a restriction from the iPad/tab/smart phone.

If you are connecting via a standard WiFi network connection, you should be able to access the service functions.

Jughead:

--- Quote from: mibridger on June 19, 2019, 08:48:18 PM ---Hi again,
How do I invoke D2D mode?
I looked up Device 2 Device mode, but I don’t know how to activate it.

Kind regards,

Mark.

--- End quote ---

The D2D mode is activated by pressing the small button on the back of the GS911. 



Connect the device to the diag port on your bike.  Press the small red button on the back of the unit so that the D2D LED lights up.  You will now have an AP named GS911_XXXXX (where "XXXXX" is your device serial number).  Simply connect to it and open 10.0.0.1 on your device browser.

mibridger:
Hi Jughead,

Thanks for all your advice, I decided to download the PC version and use that to connect to the GS911 WiFi.

I was then able to reset the service date as I wanted to.

I think I will use the PC in preference to the iPad in future.

Thanks again for your help.

Kind regards,

Mark.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version