General Category > Introduce yourself...

New here

(1/3) > >>

mibridger:
Hi all,

I am new here, I just bought a GS911 from a former BMW owner in the UK.

I have a 2015 S1000RR and a 2017 S1000XR

The RR is being replaced soon (hopefully) by a 2019 RR

I need to get the adapter cable for my XR as it has the D type OBD connector.

I also need to download the right software, I have a PC and an iPad pro, I guess the PC would be the one to use as the iPad has no USB connections.

Cheers,

Mark.

Jughead:
Hi Mark, and welcome.

Did you purchase the yellow USB/Bluetooth unit or the red Wifi unit?  Since you are concerned about your iPad not having USB connections, I can only assume it is the yellow USB/Bluetooth model.

Before purchasing adapter cables and the like, first check for compatibility with your bikes here: http://www.hexcode.co.za/products/gs-911/function-chart

mibridger:
Hi,
I have the Red WiFi version, I just received the adapter cable for my 2017 XR.

I have downloaded the IOS version of the GS911 software, will give it a try later with my iPad pro.

I might also try the Windows version as well.

Thanks for the reply.

Kind regards,

Mark.

Jughead:

--- Quote from: mibridger on June 19, 2019, 01:47:43 PM ---Hi,
I have the Red WiFi version, I just received the adapter cable for my 2017 XR.

I have downloaded the IOS version of the GS911 software, will give it a try later with my iPad pro.

I might also try the Windows version as well.

Thanks for the reply.

Kind regards,

Mark.

--- End quote ---

You actually don't need to download any software for the red WiFi unit.  You can access it from any browser.  Just put it in D2D mode, connect to the GS911 WiFi AP, and type in 10.0.0.1 in the browser address bar.  You will then be talking to the GS911 directly via the internal software.

mibridger:
Hi,
So I connected to my GS-911WIFI using my iPad Pro and the IOS version of the software.
All seems OK, I can see the various controllers, decode fault codes and reset some of them, however when I tried to use the Service function it says I must use the PC version

Is this the usual case?

Kind regards,

Mark.

Navigation

[0] Message Index

[#] Next page