Author Topic: ABS Failure can't be reseted  (Read 6650 times)

Urbandrag

  • Newbie
  • *
  • Posts: 4
  • Karma: +0/-0
  • Der Blingmeister
    • The facebook page of this guy
ABS Failure can't be reseted
« on: January 29, 2017, 12:43:01 AM »
Hi there,

A friend came to me in his 1200GS '13 (Non LC) with an ABS failure and speedo not working.
During scan, the module reads under voltage event and rear sensor not responding but both failures were not present, so I cleared them, I performed another two or three scans to confirm the failures are gone but the abs light still blinks and speedo doesn't work.
Any input?
Thanks in advance.

Regards from Argentina.
Diego aka The Urbandrag
www.facebook.com/Urbandrag

Jughead

  • Beta testers
  • Hero Member
  • *
  • Posts: 768
  • Karma: +51/-3
    • Dual Sport Motorcycle Clinic
Re: ABS Failure can't be reseted
« Reply #1 on: February 06, 2017, 08:17:02 PM »
Rear sensor is most likely buggered.  Or the cable had been pinched and is shorting just where it passes the forward mounting bolt of the torsion bar.

Also, remove the rear sensor and inspect it.  You may find a Christmas tree of metal swarf on the end of it.  Would indicate an imminent bearing failure.
« Last Edit: February 06, 2017, 08:19:01 PM by Jughead »