Print Page - K-line 2 status Stuck High

Title: K-line 2 status Stuck High
Post by: markinaz on April 23, 2015, 10:29:11 PM

What does this mean?

2003 K1200GT. ABS is not functioning. No tail or stop lighting. No speedometer. When the connector to the ABS unit is unplugged, k-line 2 status reports OK. Plugged in, status changes to "stuck high".

TIA

Mark

Title: Re: K-line 2 status Stuck High
Post by: WayneC on April 24, 2015, 03:08:37 AM

Dead ABS :'( ,

A defective ECU can hold the line high or low, on your model the ABS must be on the second diag pin of the diagnostics connector hence the message K Line 2

Title: Re: K-line 2 status Stuck High
Post by: markinaz on April 26, 2015, 07:07:35 AM

Thanks for the info, a defective ABS controller was what I feared.
What does "stuck high" mean? Pressure? Current? Voltage? Something else?

Mark

Title: Re: K-line 2 status Stuck High
Post by: WayneC on April 26, 2015, 07:15:11 AM

Basically stuck at 12v, stuck low would be at 0v, also checked with a Pro mechanic mate of mine, not unusual in the cars at least

Title: Re: K-line 2 status Stuck High
Post by: markinaz on April 26, 2015, 02:47:45 PM

Thanks!

GS-911 and ezCAN User Forum

General Category => R Series => Model Specific Discussions => Technical => GS-911 => R1100 models => Topic started by: markinaz on April 23, 2015, 10:29:11 PM