v2611.1 will cause an error code.
I was doing an oil change on my 2024 BMW R1250RT and hooked up my GS911 to reset the service reminder.
I saw there was a new version of software available do I downloaded it. (v2611.1 was installed)
I completed the Service Reminder process and then navigated to the Engine Controller\Service Functions\Configurations menu.
I selected "reset throttle twistgrip"
You're asked to turn off the ignition, which I did and then a status bar appears counting down to 0.
But mine stopped at 30% progress. I wanted 45 minutes and it stayed stuck at 30%.
So I turned the ignition back on and the message stated that the Throttle Grip Sensor, Adaptation not completed process hadn't been completed.
When you try and clear this code, you get another message stating some codes cannot be cleared.
I filed a ticket with HEX and was told to install v2610.10 and this solved the problem.
Not sure what announcements HEX will make, but wanted to post it here.
More importantly, this set an error code in the Engine Control unit,
RPG - Where did you get v2610.10?
From HEX.