Hello everybody,
Just connected the GS-911 to a R 1150 R double spark, and had a look to everything. Went into the hall sensor test and I beleieve I did press the start button, but without doing really the test.
And now the bike doesn't start. Took the battery cables off for a few minutes, checked the right injector and sparks on both sides, looks OK. When I put some gas directly in the cylinder by the spark hole, the bike caugh a little and stops.
What GS 911 is saying is to "remember to cycle the ignition" What does this mean?
Thank you for your help.
"remember to cycle the ignition" means that you will need to switch off the motorcycle/contact/ignition, wait a good 10 seconds or so and then switch on the ignition.
OK, thanks, that's what I've done today. Unfortunately with no better results.
Connect the GS 911 with the USB cable and start the hall senor test again and be sure that the test is regular finished.
I read some where that the not starting problems occurs if the hall sensor test is not complete finished.
Yes thanks, I did it already, even with Zoöl from Hexcode. We were on the phone this week doing it together. Anyway I might try it again. At the moment I'm trying with fuse number 5.
Quote from: GSBMW on June 06, 2014, 05:02:47 PM
Yes thanks, I did it already, even with Zoöl from Hexcode. We were on the phone this week doing it together. Anyway I might try it again. At the moment I'm trying with fuse number 5.
Good luck!
Thanks !
Please let us know if you found a solution.