Guys,
iv picked up a 2010 gsa1200 I dont know any of the bikes history etc...
First off it had a fuel level fault, so bought a genuine BMW fuel strip, got my self the HEX wifi tool, drained the fuel down , clean off internal terminals , fit the new sensor strip outside the tank for calibration,
Now as I start to do the calibration, " it says that there is NO fuel strip fitted "
When I check the the configuration of the controller " it says Lever type sensor "
just a bit confused ???? can i change the sensor type with 911 tool ???
it seems like this has been interfered with before me???
thanks jeff
Hello Jeff
So... did you resolve your problem.... did you were able to do something with the tool?
hey,
yes resolved the issue, it seems that the bike was originally built with a fuel strip, and at some point a fuel lever type sensor was installed and coded... but they never swapped the wires over ZFE plug.
so I restored factory settings on I cloud services, then i was able to change to the strip type calibrate
ah ah... ok.
Me itMs on the other way... from fuel strip to lever.
Thanks for your reply