GS-911 and ezCAN User Forum
General Category => Technical => GS-911 => Central Vehicle Electronics/ZFE/GM issues => Topic started by: dsellers on July 27, 2020, 10:48:33 PM
-
I'm getting this error code and wonder exactly what it is.
Is it a problem with the headlight itself, or the controller?
1 fault codes found:
E11430 CAN message missing (headlight status from SWE unit)
The fault is currently present.
Thanks,
Dave S.
-
Good Afternoon, What was the final solution? I am getting an intermittent headlight code but only when I hit bumps
-
Hi e7navy1999
The fault code service plan is very vague, you can check it out with the following website, just remember to remove any spaces before searching the fault code:
https://bmwfault.codes/
Check CAN bus, power supply and operation of transmit control unit.
Kind regards
Ruan
-
Thanks. I since replaced my front Genuine OEM BMW K1600GTL Front Level Sensor 37146860843 located just to the left side (rider right side0 behind the front spring. No more fault codes. I purchased a used part from ebay for $35usd. took about 30 minutes to replace, had to remove front wheel but it may be possible without so much effort. I replaced all my 6 coils at the same time at 100k US Miles. engine fault code is gone. Coils 2 and 3 were faulting since two months ago