GS-911 and ezCAN User Forum
General Category => General Discussion => Topic started by: Geko on December 10, 2013, 04:54:06 PM
-
I just bought the GS-911 USB version and while it works on two of my bikes it does not work with a brand new G650GS. It can not communicate with the Engine module, returns error "The controller is not of the expected type". Tried both the current and the beta version - same result. It does diagnose the ABS module though. Can you please tell me what is going on and how can I read the engine codes with this.
-
Hi,make sure your kill switch on handlebars is in ON position. ;)
-
nope, it's not the Kill switch etc...
the controller ID is different to what we expect for that model of bike...
I see you have logged a HelpDesk ticket too... I will investigate it through that avenue and be in contact.
will give feedback to the forum once I'm sure I have the correct answer.
best
Stephan
-
I have created a page http://www.f650gs.crossroadz.com.au/AboutGS-ECU.html (http://www.f650gs.crossroadz.com.au/AboutGS-ECU.html) on the 650GS ECU's, it is pretty basic for the moment, I will improve it further over time and we learn more about the new G650GS ECU, the pdf at the bottom of the page has what I think should be the connector pin out if anyone needs to work on one
-
the good news is that by next week we'll have a bike with this new ECU in our office... Then we'll get it sorted!!!
best
Stephan
-
OK the even better news is that we now have support for the new BMSE-13 ECU in the G650GS.
PM me if you want to help test it before we make the Beta release public.
-
Have not encountered anyone in Sydney with the new controller but if there was someone who wanted to look and check I would be happy to go and do it