GS-911 and ezCAN User Forum
General Category => R Series => Model Specific Discussions => Technical => GS-911 => R1150 models => Topic started by: JOPE on January 20, 2017, 08:02:06 AM
-
Dears,
I live in Mozambique (Matola), i have new GS-911 wifi, It is excellent !…but i am hoping for some advice on this error combination on my R1150 GS 2003:
Codes faults:
272 : Intake Air Temperature Sensor Circuit, Open-circuit or Short-circuit to Positive.
Currently present : NO
Occurrence count : 0
|
821 : Hall sensor 1, no signal – this fault will always occur if engine not running or engine not cranked before reading Fault codes.
Currently present : YES
Occurrence count : 0
|
901 : Hall sensor 2, no signal – this fault will always occur if engine not running or engine not cranked before reading Fault codes.
Currently present : YES
Occurrence count : 0
16773 : Front wheel speed abnormal
Currently present : NO
|
17910 : Brake fluid level too low
Currently present : NO
Can you help me please, any suggestions would be greatly appreciated!
Thank you.
João Diniz
-
Hello João
and welcome to GS911 forum.
Looks like you serviced your bike !
272
> disconnected sensor to open the airbox while ignition on
> delete fault code
821
> as GS911 required
> run engine and read again
> fault will disappear
901
> same as 821
16773
> difference between front and rear sensor readings
> running on centerstand with spinning wheel
> delete
17910
> brake bleeding? and didn't look for correct fluid level
> delete
After deleting fault codes run a test ride and read again while engine is running.
! Caution, pay attention for engine / oil temperature !
-
Hi Schuppi,
Thank many! :D
Engines
No fault codes found
ABS INTEGRAL
No fault codes found
My bike is perfect!
Have a nice day!
João Diniz