GS-911 and ezCAN User Forum

General Category => Technical => GS-911 => ABS related issues => Topic started by: ricknut on June 01, 2013, 02:44:48 AM

Title: 25140 error run time error
Post by: ricknut on June 01, 2013, 02:44:48 AM

Hi,

2006 K1200S. My ABS light comes on and speedometer does not work until I turn on/off/on the bike. 25140 error run time error. . any ideas? This problem has been going on for some time now. any ideas?

Title: Re: 25140 error run time error
Post by: StephanT on June 01, 2013, 02:46:47 AM

hi Rick,  pls post a complete autoscan

Title: Re: 25140 error run time error
Post by: ricknut on June 02, 2013, 01:27:24 AM

see attached autoscan report.

Title: Re: 25140 error run time error
Post by: kobus on June 03, 2013, 10:30:38 AM

Both the Alarm and the ABS controller have logged an CAN communications timeout.

The cluster (KOMBI) gets it's speed from the ABS unit via the CAN bus (and the ABS unit from the speed sensor).
Which explains why the speedometer does not work AND the ABS light comes on.

This would suggest a wiring/bad connector issue in the harness or sometimes this occurs due to low battery voltage (something to do with how the controllers boot up during low power).

Title: Re: 25140 error run time error
Post by: ricknut on June 03, 2013, 02:23:59 PM

This problem usually occurs when it is really hot. 

I suspect that the power connection to I-ABS might have corrosion. I will clear codes. I might do a ABS flush and brake fluid change. This problem has not occurred over the past couple week.  I put a new battery into to M.C. so that might help.