GS-911 and ezCAN User Forum

General Category => Technical => GS-911 => ABS related issues => Topic started by: applegate on July 28, 2014, 12:41:23 PM

Title: 24972 pressure in rear wheel circut
Post by: applegate on July 28, 2014, 12:41:23 PM

Hi I have a ABS fault on my 2005 k1200s showing 24972 pressure in rear wheel circut is to high
and 24954 internalrol module error- analogue value, front pressure sensor.
Also the rear sevo motor keeps going when key turned off and to stop this I have to disconnect the battery

What do I need to do to fix this

Title: Re: 24972 pressure in rear wheel circut
Post by: beemer on July 28, 2014, 10:52:46 PM

You have to replace plate with pressure sensors,for wheel circuit it's the one outside the unit,but you have to take the unit apart to route sensor wire correctly.

Title: Re: 24972 pressure in rear wheel circut
Post by: applegate on July 29, 2014, 06:08:59 AM

so where will I get these from

Title: Re: 24972 pressure in rear wheel circut
Post by: beemer on July 29, 2014, 07:34:44 AM

Unfortunately you can't get them new.Try to find second hand ABS modulator that someone removed due to a failure and hope that them sensors are ok.It could be any iABS modulator can bus/non can bus doesn't matter,sensors are the same.