GS-911 and ezCAN User Forum
General Category => General Discussion => Topic started by: diondbeer on September 02, 2014, 02:08:05 PM
-
Hi Guys. My F800GS has an issue. When I switched on the ignition switch yesterday the bike made a few werd noises from the various on board servos and then the ignition lights went dead. I removed the battery, it tested faulty. Put in a new unit. Ignition comes on bit the starter button will not swing the motor. Get an error EWS on the dash and a “10491: Electronic Immobiliser malfunction” error with the GS911 test tool. The error wont clear. Tried the spare key. Can’t clear fault, any ideas?
-
Perhaps the battery "outing" fried your ring antenna?
-
Replaced both pats, it's up and running again. Thought the designers of the electronics would build protection in against these things happening.
-
I am not understanding what you replaced, you said replaced both parts, what parts by name did you replace?
-
The ring Antenna and the batt.