GS-911 and ezCAN User Forum

General Category => Technical => GS-911 => ABS related issues => Topic started by: JJ MARECHAL on February 07, 2016, 01:30:50 PM

Title: ABS problem
Post by: JJ MARECHAL on February 07, 2016, 01:30:50 PM

I repaced my ABS bloc and i have the following message : 24153 Coding error.
WWhat is the problem and what can i get my bike service?


Thank you

Title: Re: ABS problem
Post by: schuppi on February 07, 2016, 02:35:43 PM

Hello,
welcome to GS911 forum.

Sorry, but that is a dealers job. Coding the ECU will be done online to make the modules speak to each other 8)

Title: Re: ABS problem
Post by: Jughead on February 09, 2016, 06:42:57 AM

Quote from: JJ MARECHAL on February 07, 2016, 01:30:50 PM

I repaced my ABS bloc and i have the following message : 24153 Coding error.
WWhat is the problem and what can i get my bike service?


Thank you

When replacing the ABS unit, you need to maintain the controller that is coded to the bike, i.e. the black box on the pump.  You need to use the one that is on the pump that came out of the bike.  It is just attached to the pump by 4 small torx screws.  Remove the screws and pull it off.  Then fit it to the new pump.

They very seldom fail so it should be ok.  Why did you replace the pump?

Title: Re: ABS problem
Post by: JJ MARECHAL on February 12, 2016, 10:10:55 PM

I had a failure of the electric motor.
I filed and open the motor to release the brushes it to run for six months and came back down.
So I ended up buying a used block.
To do I change all ABS and I did not think that this will put the electronics in default