GS-911 and ezCAN User Forum
General Category => General Discussion => Topic started by: GSBMW on June 02, 2014, 08:50:36 AM
-
Hello everybody,
Just connected the GS-911 to a R 1150 R double spark, and had a look to everything. Went into the hall sensor test and I beleieve I did press the start button, but without doing really the test.
And now the bike doesn't start. Took the battery cables off for a few minutes, checked the right injector and sparks on both sides, looks OK. When I put some gas directly in the cylinder by the spark hole, the bike caugh a little and stops.
What GS 911 is saying is to "remember to cycle the ignition" What does this mean?
Thank you for your help.
-
"remember to cycle the ignition" means that you will need to switch off the motorcycle/contact/ignition, wait a good 10 seconds or so and then switch on the ignition.
-
OK, thanks, that's what I've done today. Unfortunately with no better results.
-
Connect the GS 911 with the USB cable and start the hall senor test again and be sure that the test is regular finished.
I read some where that the not starting problems occurs if the hall sensor test is not complete finished.
-
Yes thanks, I did it already, even with Zoöl from Hexcode. We were on the phone this week doing it together. Anyway I might try it again. At the moment I'm trying with fuse number 5.
-
Yes thanks, I did it already, even with Zoöl from Hexcode. We were on the phone this week doing it together. Anyway I might try it again. At the moment I'm trying with fuse number 5.
Good luck!
-
Thanks !
-
Please let us know if you found a solution.