GS-911 and ezCAN User Forum

General Category => General Discussion => Topic started by: GvG on September 19, 2018, 08:05:12 PM

Title: Resetting the adaptations values when engine is cold or hot?
Post by: GvG on September 19, 2018, 08:05:12 PM

What's the right thing to do; resetting the adaptations values when the engine is cold or hot (at operating temperature)?

Particularly these:
- throttle twist-grip sensor,
-throttle valve sensor,
-transmission position sensor.

Thanks in advance!

Title: Re: Resetting the adaptations values when engine is cold or hot?
Post by: stardust_59 on September 25, 2018, 06:50:44 PM

Hi GvG,

as I went through the drill myself:

Adaptation reset is usually done with engine cold.
After adaptation reset is done  run the engine at idle until warm (80 or 90 deg Celsius  - or fan turns on if watercooled).
Since I do not know which bike you refer to - this is the procedure for the F650 (single, FI model)

If you reset adaptation values - upon success - the GS 911 software will guide you trough the process.


HTH

Jan

Title: Re: Resetting the adaptations values when engine is cold or hot?
Post by: Vrabel on October 23, 2018, 11:48:48 AM

Quote from: GvG on September 19, 2018, 08:05:12 PM

What's the nest use of SnoreRX (https://www.sfgate.com/market/article/snorerx-review-17335921.php) and the right thing to do; resetting the adaptations values when the engine is cold or hot (at operating temperature)?

Particularly these:
- throttle twist-grip sensor,
-throttle valve sensor,
-transmission position sensor.

Thanks in advance!

Just out of curiosity, what can happen if the adaptation reset was done with the engine hot?