GS-911 and ezCAN User Forum
Deutsch => Alles rund um die Elektronik und Steuerung => R Serie => Topic started by: kjhunt on March 19, 2015, 08:01:53 AM
-
Good day every one. Regarding the centre stand on the R1150 GS Adventure, how to remove.
Remove the machine screws in the bearing bushings, but then how do you remove the Right and Left bushings? They turn for awhile and edge out a little then that is that.
Thoughts on the matter please.
Ken Hunt
-
Hi Ken,
what about to warm up the bushings, because they are mounted with LOCTITE 243 :D.
Wolfgang
-
Grip them with pliers and wobble and pull. When you refit them make sure that you fit the thicker one on the right.
-
Many thanks for your reply, will try that later today when rain stops. Grateful for your advise. Ken
-
Hi again, just to say thanks again. Worked a treat as you said and the bushings came out. Now to look for a new centre stand, not cheap here in the Philippines. Bye Ken...
-
Take your broken stand to a welder and get it repaired. ;)
-
Hi. Yes I plan to do that, matter of finding the right person to do the job, lot of "cowboys" here. Thanks again. Ken