General Category > General Discussion

Windows 10

<< < (2/3) > >>

jtostenr:
I guess I was hoping to be able to disable the servo or somehow "remove" it in the ECU.

schuppi:
" I was hoping to be able to disable the servo or somehow "remove" it in the ECU."

Hello.
No, I don't think so. That's a part of the vehicle license and no diagnostic software will be able to eliminate
those functions.
Maybe a tuner, who can change  programming of the software is able to do this.

WayneC:
On the 650GS US riders are using a resistor of between 100 and 200 ohms to "fool" the BMSC into thinking a tank Vent Valve is in place
Re programming to ECE firmware would probably be a better idea for them though

schuppi:
"On the 650GS US riders are using a resistor of between 100 and 200 ohms to "fool" the BMSC"

Hello Wayne
That's right. But that is only a solenoid valve without any response to the BMSC.

The exhaust servo is operated by a PWM signal from ECU with equivalent response about the position of the flap. :)

Dann:

--- Quote from: jtostenr on July 31, 2015, 07:11:41 AM ---Installed Windows 10 yesterday and received my GS-911 Wifi today. I was able to use the GS-911wifi Utilities however, the Downloader does not find the GS911. If I look in Device Manager the GS-911 does not appear.

I was able to set up the GS-911 with my android phone and read the codes on my S1000RR, so I know the GS-911 works. Just wish I could turn off the CEL after removing my exhaust servo.

--- End quote ---

I upgraded the GS-911 firmware and software on my Win 10 tablet today with no issues

Navigation

[0] Message Index

[#] Next page

[*] Previous page