General Category > General Discussion

Controller non-recognition

(1/3) > >>

jack basarab:
I have a 2001 R100S that just quit running the other evening.  After getting it home i tried to connect my gs911.  No matter what I do, I get the message that the controller is not recognized.  I also get a message that the battery only has 5.0 volts.  I know that isn't true because I connected a new battery and still get the same results.  The engine will turn over, but not fire.  I suspect the Hall sensor, but am unable to run a any analysis to confirm.  Has anyone run into this non recognition problem?  tia  jb

kobus:
What is the VIN of this bike?

jack basarab:
The vin # is:  WB10432A71ZB51698

schuppi:
Hello Jack,

in case of these 5V, at first check fuse F4 15A. And in addition the relays for DME in the fusebox at the left side in front of the
fuel tank.
Then we search for other issues.

jack basarab:
The F4 fuse is good, but I can find no reference to the DME relays.  Which one/ones are they in the left relay bank?  Front to back there is a yellow, two small black and one larger black relay. 

Navigation

[0] Message Index

[#] Next page