General Category > ABS related issues

K1200RS ABS Module can not be found

<< < (2/2)

guysat:

--- Quote from: marchyman on March 28, 2015, 05:07:06 AM ---You didn't say if you were using the PC app or not.   The note on the http://www.hexcode.co.za/products/gs-911/function-chart page says:

ABS-II : Also known as ABS-2 - the predecessor to integral ABS (iABS, also known as servo assisted) on most R850, R1100, R1150 and older K1200 models. (*Due to protocol timing constraints, ABS-II is ONLY supported in the Windows versions of the software!)

Were you using the app or the built in functions of the wifi version?

--- End quote ---

All sorted wish I had read that, ABS connected with no issues once using a PC... ::)

guysat:
Well ABS lights have decieded to make a re-appearance, straight after I pulled out of a gritty lay-by and the rear wheel spun up a little on the gravel, (strange as this has no braking involved)
I updated the GS-911 unit before trying to connect with bike, then connected to bike and was able to reset fault codes using a 'Mac computer' and all is good again   :D

Keep up the excellent work with this GS-911 unit  :D

mike d:
Did you read the fault code before clearing it?

Perhaps you have an underlying issue.

Mike

Navigation

[0] Message Index

[*] Previous page