General Category > ABS related issues

24972 pressure in rear wheel circut

(1/1)

applegate:
Hi I have a ABS fault on my 2005 k1200s showing 24972 pressure in rear wheel circut is to high
and 24954 internalrol module error- analogue value, front pressure sensor.
Also the rear sevo motor keeps going when key turned off and to stop this I have to disconnect the battery

What do I need to do to fix this

beemer:
You have to replace plate with pressure sensors,for wheel circuit it's the one outside the unit,but you have to take the unit apart to route sensor wire correctly.

applegate:
so where will I get these from

beemer:
Unfortunately you can't get them new.Try to find second hand ABS modulator that someone removed due to a failure and hope that them sensors are ok.It could be any iABS modulator can bus/non can bus doesn't matter,sensors are the same.

Navigation

[0] Message Index