General Category > General Discussion

ESA calibration

<< < (2/2)

Inspector Gadget:
The RT does not have preload adjustment in for the front shock, the bulky external part.
Which is also why the hall sensor positions are all 0, the sensor does not exist either.

Only the damping, the small needle inside which controls the flowspeed of the fluid in and out of the small chamber, exists on the front shock. Which is the wire you do see.

Pre-load is the larger steppermotor which compresses the spring.
And on the 1200RT that only exists on the rear shock. (shock)

Luma46:

--- Quote from: Inspector Gadget on July 17, 2014, 09:07:18 PM ---The RT does not have preload adjustment in for the front shock, the bulky external part.
Which is also why the hall sensor positions are all 0, the sensor does not exist either.

Only the damping, the small needle inside which controls the flowspeed of the fluid in and out of the small chamber, exists on the front shock. Which is the wire you do see.

Pre-load is the larger steppermotor which compresses the spring.
And on the 1200RT that only exists on the rear shock. (shock)

--- End quote ---

Thank you very much for your explanation and help, much appreciated.

Navigation

[0] Message Index

[*] Previous page