Author Topic: Engine won't start after use of the GS 911  (Read 13466 times)

GSBMW

  • Newbie
  • *
  • Posts: 20
  • Karma: +0/-0
Engine won't start after use of the GS 911
« on: June 02, 2014, 08:50:36 AM »
Hello everybody,

Just connected the GS-911 to a R 1150 R double spark, and had a look to everything. Went into the hall sensor test and I beleieve I did press the start button, but without doing really the test.


And now the bike doesn't start. Took the battery cables off for a few minutes, checked the right injector and sparks on both sides, looks OK. When I put some gas directly in the cylinder by the spark hole, the bike caugh a little and stops.

What GS 911 is saying is to "remember to cycle the ignition" What does this mean?

Thank you for your help.

Inspector Gadget

  • Full Member
  • ***
  • Posts: 126
  • Karma: +6/-0
Re: Engine won't start after use of the GS 911
« Reply #1 on: June 02, 2014, 09:58:34 AM »
"remember to cycle the ignition" means that you will need to switch off the motorcycle/contact/ignition, wait a good 10 seconds or so and then switch on the ignition.

GSBMW

  • Newbie
  • *
  • Posts: 20
  • Karma: +0/-0
Re: Engine won't start after use of the GS 911
« Reply #2 on: June 02, 2014, 07:53:27 PM »
OK, thanks, that's what I've done today. Unfortunately with no better results.

waldru

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: Engine won't start after use of the GS 911
« Reply #3 on: June 06, 2014, 03:36:55 PM »
Connect the GS 911 with the USB cable and start the hall senor test again and be sure that the test is regular finished.
I read some where that the not starting problems occurs if the hall sensor test is not complete finished.

GSBMW

  • Newbie
  • *
  • Posts: 20
  • Karma: +0/-0
Re: Engine won't start after use of the GS 911
« Reply #4 on: June 06, 2014, 05:02:47 PM »
Yes thanks, I did it already, even with Zoöl from Hexcode. We were on the phone this week doing it together. Anyway I might try it again. At the moment I'm trying with fuse number 5.

waldru

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: Engine won't start after use of the GS 911
« Reply #5 on: June 06, 2014, 06:34:36 PM »
Yes thanks, I did it already, even with Zoöl from Hexcode. We were on the phone this week doing it together. Anyway I might try it again. At the moment I'm trying with fuse number 5.
Good luck!

GSBMW

  • Newbie
  • *
  • Posts: 20
  • Karma: +0/-0
Re: Engine won't start after use of the GS 911
« Reply #6 on: June 06, 2014, 09:17:41 PM »
Thanks !

waldru

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: Engine won't start after use of the GS 911
« Reply #7 on: June 07, 2014, 07:02:08 AM »
Please let us know if you found a solution.