General Category > R1200 models

GS 911 does not recognize my Bike

(1/3) > >>

rkiaer:
Hello All,

I have a R1200GS K50 2013/2014, I connect my gs911 correctly to my bike, I have VBAT=12,4V and VING=0,04V.
My device does not recognize my bike, when try to get ECU information for example allways I receive "No response from controler"

Anyone get someti-me this kind of error.

marchyman:
The current GS-911 will never work with the K50.   If you do a bit of searching you'll probably find the post by Stephan saying exactly why.  Something do with different interfaces (even though the connector is the same).   The story is the same for the K1600.

rkiaer:
Thanks for your reply, now I have a little yellow brick to put over my desk , my gs911 became a useless device.

StephanT:
or...

your new K50 became useless to a very useful yellow GS-911 !  :)

on a serious note: the new K001 generation (K48, K50, K51, K52 and K17) have a completely new diagnostic interface... you will note that the pins differ... the physical interface is different, the protocol differs...  The did this with cars some years back... nothing we (or your GS-911) could do about it...

best
Stephan

rkiaer:
Thanks for your reply, I sold my GS911 to my friend that have one GS1200 2011, and he is happy with the new toy :-)
At the end of this year I will go to USA and I hope that the new GS911 will be available.
This device is awesome!!

Best Regards and keep going on the new GS911 challenge :-)

Navigation

[0] Message Index

[#] Next page