General Category > GS-911 Android

Problem of ABS fault cleaning in Android version.

(1/1)

savaskayan:
Hello,
| I am using an android version 1.2 with my GS-911
 I have a 2002 R1150gs Adventure.
and  Phone (HTC one) and Gs-911 to phone bluetooth  connection isn't problem,and the android program show engine faults,clears o.k.
but I dont see ABS faults and clean them.Because Program says about "ABS unit not connected or old  then ABS 2"
when  I connect GS-911 to laptop isnt problem and I see ABS faults and clean them.
Why I'am not see and clean ABS fault with android version ?

marchyman:
I think your GS uses ABS-II, correct?  If so then pay attention to the note on the bottom of http://www.hexcode.co.za/products/gs-911/compare


--- Quote ---Note: The mobile versions do not support the very old control units (ABS-II, MA2.1, MA2.2), due to their old antiquated protocols and related timing constraints.
--- End quote ---

savaskayan:

--- Quote from: marchyman on March 08, 2014, 06:12:08 AM ---I think your GS uses ABS-II, correct?  If so then pay attention to the note on the bottom of http://www.hexcode.co.za/products/gs-911/compare


--- Quote ---Note: The mobile versions do not support the very old control units (ABS-II, MA2.1, MA2.2), due to their old antiquated protocols and related timing constraints.
--- End quote ---


--- End quote ---
My friend,
Ms gs-911 is a GS-911blu Enthusiast and not problem  connecting with bluetooth.
other controller is ok.
only abs controller function not working.
according to ,I think that It's should clear abs faults,am I right ?

marchyman:
Again, read the light grey text below the chart.  That describes your bike, doesn't it?

Navigation

[0] Message Index