General Category > General Discussion
Husky TR650
Britmech:
Hi
Does anyone know if the 911 works on the TR 650 Husky ?
mike d:
Hi,
No it doesn't. For models covered have a look at:
http://www.hexcode.co.za/products/gs-911/function-chart
Mike
Haakon:
The Husquarna (BMW) models are not GS911 compatible.
But, out of curiosity, could you please send me a picture of your ECU box and the "diagnostic plug".
It HAS a engine very much alike the GS models.... did BMW use that engine and change the ECU?
Other ECU maps, sure, but make a new ECU???
Haakon
Britmech:
Thanks for the replies i do not have a TR650 just thinking about one.
Haakon are you still working with 650GS ECU's ? as I am sure we have crossed paths on other forum's (f650UK) and GS911 (the old forum) I have problems with my BMS-C not shutting down and have a small draw with it, I now have 2 other BMS units but really want to keep the 5000 software. So at the moment I just take the fuse out.
Haakon:
Yes, I sure am the same Haakon :D
I guess this is not actually a Hexcode matter so feel free to contact me by mail! (found on my "info" page here)
The total draw should be in the region of a few milliamps when the bike is sleeping.
I do not remember but think the BMS-C is totally shut off... will check.
Have you tried the spare BMS-C`s. If they shut off properly its the BMS-C that has a strange fault ???
If they too stay "ON" I suspect you have a "short circuit", most probably in the ignition switch region?
I am thinking of the wires insulation getting brittle and ...
------------------------
Yes, I am back to BMS-C "work" after 10 years :)
If we are sure the fault is in your old BMS-C, check you spare ECU`s, using the GS911!!
With a bit of luck you can have a spare with the 5000 map? :D
I now use a ECU from a CS, that was bought with the with the 5000 map- and yes, I love it!
If none of them have the 5000 map.... I do have chips of all sorts- IF you want to do all that work.
(change the chip)
The 8000 map is not too bad, but you must buy the other type of injector to use it.
Contact me by mail,
It was nice to be "remembered" :D
Haakon
--- Quote from: Britmech on January 26, 2014, 12:43:21 AM ---Thanks for the replies i do not have a TR650 just thinking about one.
Haakon are you still working with 650GS ECU's ? as I am sure we have crossed paths on other forum's (f650UK) and GS911 (the old forum) I have problems with my BMS-C not shutting down and have a small draw with it, I now have 2 other BMS units but really want to keep the 5000 software. So at the moment I just take the fuse out.
--- End quote ---
Navigation
[0] Message Index
[#] Next page
Go to full version