General Category > GS-911
Tyre pressure sensors k1600 gtle
(1/1)
Voodles:
i have replace both my sensors as was getting erratic readings. this has cured my problem,,, i cleared the fault codes then checked the sensors. they both gave a reading of 5 kpa when i know i had 3 kpa in them. is there a way to calibrate the gs911. the reading on the bike display is correct. thanks
Ruan:
Hi Voodles
You'll need to wake up those sensors to see what the actual reading is, we've found -50 bar as a placeholder value before, then once the sensors are awake, standard 2.5-3bar is displayed.
If this value is displayed after wakeup, it's most likely an issue with the sensor not transmitting it's reading correctly. There isn't a way for us to calibrate the sensor, we can only learn it to the ECU.
Kind regards
Ruan
Navigation
[0] Message Index
Go to full version