General Category > Central Vehicle Electronics/ZFE/GM issues

An other strip to float fuel level question

(1/1)

de walque:
Hello to all of you, and thanks for your time
So on this bike gs1200adv 2010 i did change the fuel strip level to the float type
Did change two pin on one connector to the zfe module  (a high one )
With my gs tool i try to code the zfe module, but it say turn off the switch and wait. 
a bar graph  will appear... but nothing will happen
i will shot a error like a server fault...
did try it 4 or five time always same result
Do some one have an idea?
Here the vin of the bike:   zy04840
Thanks again

Ruan:
Hi De walque

Can you please send through a full autoscan to support@hexinnovate.com, perhaps also upload your log files for us to review the error, steps below:
https://www.hexgs911.com/faq/how-do-i-send-my-debug-log-files/

Kind regards
Ruan

de walque:
Hello Ruan
So... i am sorry.  I can close this help request now.  perhaps it was my error.
The last attempt did work.   i don't know exactly what i've done differently.  i know that when it prompt to turn off ignition and wait, i did it but not troo much
also, there is a window, that will ask you to enable or disable  something, i don't remembrer exactly what... i changed that, then make my coding et voila. all is good.
Sorry not to have updated that post.
Still love my gs911

Navigation

[0] Message Index