General Category > GS-911

2010 GSA1200 another fuel level question

(1/1)

jeffwhite:
Guys,

iv picked up a 2010 gsa1200 I dont know any of the bikes history etc...

First off it had a fuel level fault, so bought a genuine BMW fuel strip, got my self the HEX wifi tool, drained the fuel down , clean off internal terminals , fit the new sensor strip outside the tank for calibration,

Now as I start to do the calibration, " it says that there is NO fuel strip fitted "

When I check the the configuration of the controller " it says Lever type sensor "

just a bit confused ???? can i change the sensor type with 911 tool ???


it seems like this has been interfered with before me???

thanks jeff

de walque:
Hello Jeff
So... did you resolve your problem.... did you were able to do something with the tool?

jeffwhite:
hey,

yes resolved the issue, it seems that the bike was originally built with a fuel strip, and at some point a fuel lever type sensor was installed and coded... but they never swapped the wires over ZFE plug.

so I restored factory settings on I cloud services, then i was able to change to the strip type calibrate

de walque:
ah ah... ok.
Me itMs on the other way... from fuel strip to lever. 
Thanks for your reply

Navigation

[0] Message Index