General Category > Central Vehicle Electronics/ZFE/GM issues

Electric Screen not working

(1/3) > >>

HenryJ:
Hi
 My 2006 K1200gt electric screen is not working ...I have a spare motor which wont work when connected either. However if I bring a 12V supply and earth to the yellow and green wires going to the motor it will move up and down [by reversing polarity].
When I Check with the GS911 I get fault code 41765 ...on ZFE  I have attached autoscan.  Also when I use live data I can see switches working when pressed; on/off. There is a line for windscreen sensor which reads 0, also further down the list there are two windscreen powers only one of which is showing...
Any help would be appreciated.
Regards
Henry

schuppi:
Hi Henry
There is a microswitch on the right side of the screen mechanic to fix the end positions of the screen. Please look for the wiring and cable connectors.
May be the switch is faulty.

Merry christmas everybody

HenryJ:
Hi
I have completely removed the mechanism and checked the wiring....and there definitely is no microswitch or wiring going to the mechanism...except the plug for the motor....the limits must be detected by the ZFE...as far as I can see.
Regards
Henry

schuppi:
Hi Henry
You're right, there is no outside switch. It must be included in the actuator.
But now i am out, can't find any wiring diagram. Sorry

HenryJ:
ok Thanks
Would appreciate a wiring diagram if you can.
Still feel the problem is with the ZFE.
But hope it is not.!

Navigation

[0] Message Index

[#] Next page