General Category > General Discussion

G650GS - "The controller is not of the expected type"

(1/2) > >>

Geko:
I just bought the GS-911 USB version and while it works on two of my bikes it does not work with a brand new G650GS. It can not communicate with the Engine module, returns error "The controller is not of the expected type". Tried both the current and the beta version - same result. It does diagnose the ABS module though. Can you please tell me what is going on and how can I read the engine codes with this.

beemer:
Hi,make sure your kill switch on handlebars is in ON position. ;)

StephanT:
nope, it's not the Kill switch etc...

the controller ID is different to what we expect for that model of bike...

I see you have logged a HelpDesk ticket too... I will investigate it through that avenue and be in contact.

will give feedback to the forum once I'm sure I have the correct answer.

best
Stephan

WayneC:
I have created a page http://www.f650gs.crossroadz.com.au/AboutGS-ECU.html on the 650GS ECU's, it is pretty basic for the moment, I will improve it further over time and we learn more about the new G650GS ECU, the pdf at the bottom of the page has what I think should be the connector pin out if anyone needs to work on one

StephanT:
the good news is that by next week we'll have a bike with this new ECU in our office... Then we'll get it sorted!!!

best
Stephan

Navigation

[0] Message Index

[#] Next page