General Category > Technical

datalog sampling frequency

<< < (3/3)

WayneC:

--- Quote from: the_grizzli on December 08, 2024, 01:20:00 PM ---Hi !
to control the fuel table, I therefore need to record these 6 parameters

"Engine RPM"
"Throttle Position"
"Oxygen Sensor Voltage (Bank 1, Sensor 1)"
"Lambda Sensor Output"
"Short-Term Fuel Trim (Bank 1)"
"Long-Term Fuel Trim (Bank 1)"

I connect my smartphone via wifi to my gs-911 and I record.
the recording rate and the lag between the different recordings is prohibitive... the recorded log is unusable...
how can HexInnovate improve this?

thanks

--- End quote ---

You did not mention whether you logged to SD card then downloaded the file after ending logging

Overall logging speed limitation is speed of CAN BUS & remember O2 sensors are the rather slow

Perhaps lodge a support ticket with Hexcode  https://www.hexgs911.com/contact-us/

the_grizzli:

170 / 5 000
yes, yes
i was connected to the sd card, then i tried to use the downloaded csv file.
we can also see very well the timing differences between the lines..

Navigation

[0] Message Index

[*] Previous page