General Category > GS-911
anyone familiar with this code? 0x3A1122 Thanks!
(1/1)
lil.s1k:
bike keeps shutting off for this code 0x3A1122 (Fuse activated for Ignition component protection, overload)
GS Jim:
This is what I heard :
Disconnect all components specified below and delete the fault memory.
With all components disconnected, if the fault memory entry is
present: Check the wiring harness for insulation damage.
not present: Reconnect all components step by step until the fault is entered again.
Components of the component group 2:
Fuel injectors
Ignition coils
If installed:
Unfiltered-air flap controller
After rectifying the fault, reset the mixture preparation adaptation values.
hoss_cartwright:
--- Quote from: lil.s1k on August 03, 2024, 01:40:38 AM ---bike keeps shutting off for this code 0x3A1122 (Fuse activated for Ignition component protection, overload)
--- End quote ---
Did a solution present itself? did you take Jim's advice?
Navigation
[0] Message Index
Go to full version