General Category > GS-911

Switch between Lever type and Film type fuel sensors

<< < (3/3)

botus:
on the other tool it only has manual selection of the bits you change...

for the big tank bikes (GSA) due to the size of the fuel load and the float mucking about - aside from the strip / lever change, there's another setting to enable - to actually switch off fuel level readings if the side stand is down...

I've had issues with GS911 hanging whilst doing stuff - need to escalate or they'll never know to investigate...  and make sure on long procedures you have battery support to keep volts up

Skim:
Also watching this. Did the swap from strip to lever with GS911 by doing the pin change and connecting a 41 Ohm (I think) resistor. Seems there are now more reliable strips available. Consider swopping back, provided this apparent gremlin is sorted.

de walque:
I can close this help request.
It was my fault, i think. Bad manipulation of the software i think.
But it worked.....   so far so good.

Navigation

[0] Message Index

[*] Previous page