General Category > Central Vehicle Electronics/ZFE/GM issues

Left Rear Turn Signal Indicator, Open Circuit 0x800E98 - 22' F850GSA

(1/1)

RichCox:
Newbie here... just got the GS911 for a couple issues. First was service interval reset, i was able to complete it. Next, when turning on left indicator, the front flashes fast and nothing on the rear. Then i get a message on the TFT, left rear indicator faulty" the code from GS911 is Left Rear Turn Signal Indicator, Open Circuit 0x800E98.
backstory... i was installing a camera system on the bike and in searching for the trigger wire, i inadvertently popped the 10v fuse several times. Every wire that was attempted was covered back up with heat wrap. I even followed the LR indicator harness from start to as far as i could see (before it gets grouped with all other clusters) to ensure all wires are secured and covered....

thoughts on if it is a relay or do i need to go buy a new LR LED assembly?

Thanks in advance.

GS Jim:
Try plugging it into the right side to see if the problem follows it, if not then it is not the light.

RichCox:
I did swap the rears and the problem did persist. After swap, turning on the right indicator illuminated the left signal, while turning the left on did not illuminate the right. I forgot i did that. so I know the light works, any other ideas?

candysailt:
When connecting an LED light bar to your vehicle's battery, only use a relay. You can wire it without a relay, but you must be extra cautious and double-check everything.
paper minecraft

Navigation

[0] Message Index