General Category > GS-911

New Firmware/Software Available (April 2023)

<< < (11/12) > >>

Skim:
Really like some of the new features. Specifically the .pdf printing for ease of maintaining service history.
A few queries on values. See attached.
1.   Autoscan.
a.   I assume the Date value of 0210 denotes February 2010?
2.   Tyre Pressure Monitor (RDC) Realtime values
a.   Tyre temp indicated as 215 C. Actual was 19 C.
b.   Tyre Pressure indicated as 5.1 Bar on both tyres. Actual was 2,8 Rear and 2,5 Front.
3.   Selected Engine controller Real Time values
a.   Knock Sensor 1 Voltage 26,93 Volts. Is this correct unit or should it be mV?

Will hopefully do some more work during the next two weeks as service is almost due.

Unable to add .jpg attachments.

GS Jim:
On the tire pressure/temp those look like what you get when the sensors are not awake. Either use a wake up tool or ride the bike and then check before killing power.

Skim:

--- Quote from: GS Jim on April 17, 2023, 06:54:58 PM ---On the tire pressure/temp those look like what you get when the sensors are not awake. Either use a wake up tool or ride the bike and then check before killing power.

--- End quote ---

Thanks Jim. Makes sense, will check.

Francois Barnard:
Hi GS-911 forum users,

July 2023 updates have been released. Please refer to the news page for more info: https://www.hexgs911.com/news/july-2023-software-and-firmware-updates/

Kind regards,
Francois

karlh:
To Hex Innovate:  Please don't post these messages on the end of an old thread.  Start a new thread for each new release.

Navigation

[0] Message Index

[#] Next page

[*] Previous page