General Category > GS-911

ABS lower lamp

<< < (2/2)

GSBMW:
Hmmm, it is so long and complicated to decode the autoscan?

Jughead:
OK then.

Next thing I would check is whether you have power to the lamp.  If not, trace the wire back through the harness.  You may well find a break or a short circuit somewhere.  The wiring below the LHS of the battery bracket is particularly susceptible to chaffing and short circuits.

GSBMW:
Yes, I have power to the lamp.

Ignition on, the upper light flashes and when I ground white/black cable the lower light turns on without flashing.

All the harness's cable ties are off.

So when the GS 911 is saying "Warning lamp fault" it simply means that in fact it can come from anywhere else.

Jughead:
Surely if you have power to the globe connector, the globe should be lit?!  If not, I would suspect the globe (despite the fact that it looks "good"), or a bad connection in the globe fitting.

GSBMW:
Hello Jughead,
Thank you for being back one year after. Finally I had to change the whole harness because PO forgot to put back on the earth coming from ABS module.

Navigation

[0] Message Index

[*] Previous page

Go to full version